Zebra Technologies 1050020011570 Printer User Manual


 
Configuration
Control Panel Parameters
86
11342L-001 Rev. A 105SL User Guide 6/30/06
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press PLUS (+) to select YES.
If your printer is set to require a password, you are prompted to enter
the password.
2. Enter the password. For instructions, see Change Password-Protected
Parameters on page 76.
The display shows INITIALIZE FLASH?
3. Press PLUS (+) to select YES.
The display shows
ARE YOU SURE?.
4. Do you wish to continue?
Press
MINUS (-) to select NO to cancel the request and return to the
INITIALIZE FLASH prompt.
Press
PLUS (+) to select YES and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY. If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING E: MEMORY and
PRINTER IDLE.
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
Table 9 • Printer Parameters (Page 8 of 19)
Parameter
Action/Explanation
INIT FLASH MEM.
YES