Zebra Technologies 1050020011570 Printer User Manual


 
Printer Setup
Connect the Printer to a Power Source
24
11342L-001 Rev. A 105SL User Guide 6/30/06
Power Cord Specifications
Depending on how your printer was ordered, a power cord may or may not be included. If one
is not included or if the one included is not suitable for your requirements, refer to the
following guidelines:
The overall cord length must be less than 9.8 ft. (3.0 m).
The cord must be rated for at least 10 A, 250 V.
The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference. The third wire in the power cord grounds the connection (Figure 9).
Figure 9 • Power Cord Specifications
Figure 10 • International Safety Organization Certifications
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific, three-conductor grounded
plug configuration.
1
AC power plug for your country—This should bear
the certification mark of at least one of the known
international safety organizations (Figure 10).
2
3-conductor HAR cable or other cable approved for
your country.
3
IEC 320 connector—This should bear the
certification mark of at least one of the known
international safety organizations (Figure 10).
4
Length 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
2
3
1
4