Zebra Technologies 1050020011570 Printer User Manual


 
83
Configuration
Control Panel Parameters
6/30/06 105SL User Guide 11342L-001 Rev. A
Set Maximum Label Length
This parameter is used during the media portion of the calibration process.
Always set maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length (Figure 25). If the value is set
to a smaller value than the label length, the printer assumes that continuous
media is loaded, and the printer cannot calibrate.
For example, if the label length is 5.0 inches (126 mm) including the
interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length
is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).
Figure 25 • Label Length
Default: 39.0 inches (988 mm).
Range: Values are adjustable in one-inch (25.4 mm) increments.
To change the value shown:
1. Press PLUS (+) to increase the value.
2. Press
MINUS (-) to decrease the value.
Table 9 • Printer Parameters (Page 5 of 19)
Parameter
Action/Explanation
MAXIMUM LENGTH
-39.0 IN 988 MM
}
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set maximum label length to approximately
this value
1
3