Filter
Top Products
Configuration
Control Panel Parameters
82
11342L-001 Rev. A 105SL User Guide 6/30/06
Set Print Width
Determines the printable area across the width of the label given the
resolution of the printer.
Note • Setting the width too narrow can result in portions of the
label not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off the label and
on the platen roller. This setting can affect the horizontal position of
the label format if the image was inverted using the ^POI ZPL II
command.
To change the value shown:
1. Press MINUS (-) to move the cursor.
2. Press
PLUS (+) to increase the value of the digit.
To change the unit of measurement:
1. Press MINUS (-) until the unit of measurement is active.
2. Press
PLUS (+) to toggle to a different unit of measure (mm, inches,
or dots).
Table 9 • Printer Parameters (Page 4 of 19)
Parameter
Action/Explanation
PRINT WIDTH
- MM +