ZyXEL Communications P-2302 Network Card User Manual


 
Chapter 9 SIP
P-2302HWUDL-P1 Series User’s Guide
139
9.3.3 SIP QoS Screen
Use this screen to maintain ToS and VLAN settings for the ZyXEL Device. To access this
screen, click VoIP > SIP > QoS.
Enable Select this if you want to hear a waiting (beeping) dial tone on your phone when
you have at least one voice message. Your VoIP service provider must support
this feature.
Expiration Time Keep the default value, unless your VoIP service provider tells you to change it.
Enter the number of seconds the SIP server should provide the message waiting
service each time the ZyXEL Device subscribes to the service. Before this time
passes, the ZyXEL Device automatically subscribes again.
Fax Option This field controls how the ZyXEL Device handles fax messages.
G.711 Fax
Passthrough
Select this if the ZyXEL Device should use G.711 to send fax messages. The peer
devices must also use G.711.
T.38 Fax Relay Select this if the ZyXEL Device should send fax messages as UDP or TCP/IP
packets through IP networks. This provides better quality, but it may have inter-
operability problems. The peer devices must also use T.38.
Call Forward
Call Forward
Table
Select which call forwarding table you want the ZyXEL Device to use for incoming
calls. You set up these tables in VoIP > Phone Book > Incoming Call Policy.
Caller Ringing
Enable Select the check box if you want to specify what tone people hear when they call
you. The ZyXEL Device provides a default tone, but you can add additional tones
using IVR. See Section 9.2 on page 132 for more information.
Caller Ringing
Tone
Select the tone you want people to hear when they call you. You should setup
these tones using IVR first. See Section 9.2 on page 132 for more information.
On Hold
Enable Select the check box if you want to specify what tone people hear when you put
them on hold. The ZyXEL Device provides a default tone, but you can add
additional tones using IVR. See Section 9.2 on page 132 for more information.
On Hold Tone Select the tone you want people to hear when you put them on hold. You should
setup these tones using IVR first. See Section 9.2 on page 132 for more
information.
<Back Click this to return to the SIP Settings screen without saving your changes.
Apply
Click this to save your changes and to apply them to the ZyXEL Device.
Cancel Click this to set every field in this screen to its last-saved value.
Table 58 VoIP > SIP > SIP Settings > Advanced
LABEL DESCRIPTION