Filter
Top Products
Chapter 5 Wireless LAN
P-2302HWUDL-P1 Series User’s Guide
83
Figure 37 Wireless LAN: General
The following table describes the general wireless LAN labels in this screen.
5.4.1 No Security
Select No Security to allow wireless stations to communicate with the access points without
any data encryption.
Table 30 Wireless LAN: General
LABEL DESCRIPTION
Enable
Wireless LAN
Click the check box to activate wireless LAN.
Name(SSID) (Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer
connected to the wireless LAN and you change the ZyXEL
Device’s SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must
then change the wireless settings of your computer to
match the ZyXEL Device’s new settings.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Channel
Selection
If two wireless networks overlap, they should use a different channel.
Like radio stations or television channels, each wireless network uses a specific
channel, or frequency, to send and receive information.
Select a channel from the drop-down list box.
Security Mode See the following sections for more details about this field.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to reload the previous configuration for this screen.