Filter
Top Products
Chapter 7 - SCSISelect Configuration Utility
7-11
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( =default)
Adaptec AIC7880 Ultra/Ultra W SCSISelect (TM) Utility v1.2
AIC-7880 Ultra/Ultra W at Bus:Device 00:10h
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID...................................7
SCSI Parity Checking....................................Enabled
Host Adapter SCSI Termination....................Low ON/High ON
Additional Options
Boot Device Options......................................Press <Enter>
SCSI Device Configuration............................Press <Enter>
Advanced Configuration Options...................Press <Enter>
<F6> - Reset to Host Adapter Defaults
*
SCSI Device Configuration
SCSI Device ID #0 #1 #2 #3 #4 #5 #6 #7
Initiate Sync Negotiation.................yes yes yes yes yes yes yes yes
Maximum Sync Transfer Rate ......20.0 20.0 20.0 20.0 20.0 20.0 20.0 20.0
Enable Disconnection....................yes yes yes yes yes yes yes yes
Initiate Wide Negotiation................yes yes yes yes yes yes yes yes
--------------------Options Listed Below Have NO EFFECT if the BIOS is Disabled -----------------
Send Start Unit Command..............no no no no no no no no
SCSI Device ID #8 #9 #10 #11 #12 #13 #14 #15
Initiate Sync Negotiation.................yes yes yes yes yes yes yes yes
Maximum Sync Transfer Rate ......20.0 20.0 20.0 20.0 20.0 20.0 20.0 20.0
Enable Disconnection....................yes yes yes yes yes yes yes yes
Initiate Wide Negotiation................yes yes yes yes yes yes yes yes
--------------------Options Listed Below Have NO EFFECT if the BIOS is Disabled -----------------
Send Start Unit Command..............no no no no no no no no
SCSI Device Configuration
Figure 7-7 SCSI Device Configuration Screen for AIC-7880
Use the cursor keys (↑ ↓) to move between options. Press Enter to display a pop-
up menu with a selection of values. Use the cursor keys (
↑ ↓) to select a value,
and press Enter to make your selection.