Filter
Top Products
Index
3
Mouse, 2-6
N
Num lock after boot, 5-4, 5-11
O
Onboard communication ports, 5-16, 5-18
Onboard PS/2 mouse (IRQ12), 5-16, 5-20
Onboard SCSI, 5-23, 5-24
Operation mode, 5-16, 5-20
P
Parallel port base address, 5-16, 5-19
Parallel port operation mode settings, 5-20
Parallel port settings, 5-19
PCI bridge (PB), 1-5
PCI IRQ setting, 5-23
PCI slots, 5-24
PCI system configuration, 5-2, 5-23, A-7
Power cable connections, C-9
Power on password, 5-16, 5-22
Power subsystem, 3-10, C-1, C-11
Power supply upgrade, C-2
Power switch, 1-9
Preparing the system unit, 2-3
R
RDM, 5-2, 5-28, 6-1, 6-2
RDM button, 1-12
Rear panel, 1-13
Reconfiguring the system, 4-17
Redundant power supply subsystem, 1-6
Remote Device Manager (RDM), 5-28, 6-1, 6-2
Removing a battery box, C-18
Removing a power supply module, C-7
Removing a SIMM, 4-14
Removing housing doors, 3-4
Reset switch, 1-9
Right panel, 3-3, 3-5
Rules for adding memory, 4-11
Running the SCSISelect utility, 7-3
Run setup, 5-1
S
SCSI backplane boards, 3-8, B-1
Channel configuration, B-5, B-6, B-7
Features, 3-8, B-1
Hard disk ID feature, B-4
Installing a SCSI hard disk, B-8, B-13
Jumper settings, B-3
Layout, B-2
SCSI parity checking, 7-2, 7-5, 7-7, 7-8, 7-29
SCSISelect configuration utility, 7-1
Default values, 7-1
SCSISelect Utility
Advanced configuration options, 7-16, 7-
26, 7-27
BIOS startup messages, 7-26
BIOS support for int13 extensions, 7-19
BIOS support for more than 2 drives, 7-2, 7-
18
Boot device options, 7-9, 7-10
Configure/view host adapter settings
menu, 7-5
Configuring multiple SCSI controllers, 7-
22, 7-29
Disk drives over 1 Gbyte, 7-18, 7-23
Enable disconnection, 7-13
Extended translation for DOS drives > 1
Gbyte, 7-18, 7-23, 7-26
Format disk, 20, 21, 27
Host adapter BIOS, 7-2
Host adapter SCSI ID, 7-2, 7-5, 7-6
Host adapter SCSI termination, 7-2, 7-5,
7-8, 7-9
Initiate sync negotiation, 7-12, 7-13
Initiate wide negotiation, 7-14
Maximum sync transfer rate, 7-12