Filter
Top Products
AcerAltos 19000 User’s Guide
5-24
PCI Slots
These parameters allow you to specify the appropriate interrupt for each of the
PCI devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11,
IRQ12, or IRQ15 to the slots.
The IRQs that can be assigned to each PCI slot are listed below:
Slots 1-3 Can be assigned IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10,
IRQ11, IRQ12, or IRQ15
Slots 4-6 Can be assigned IRQ3, IRQ9, IRQ10, IRQ11, IRQ12, or
IRQ15
To avoid conflicts, make sure that the
interrupt you assign to the PCI slot is not
used by other devices, embedded or add-on.
Press or to move between fields. Press or to select options.
5.5.2 VGA Palette Snoop
PCI devices support a palette snooping technique that enables the device to
control access to their palette registers. Set this parameter to Enabled if you
install an additional video device in an EISA bus slot. Set this parameter to
Disabled if you don’t have an additional video device installed. The default
setting is Disabled.
5.5.3 Onboard SCSI
This parameter allows you to enable or disable the onboard SCSI controller. The
default setting is Enabled.
Boot Device
This parameter allows you to enable or disable the onboard SCSI boot priority.
Setting this item to Enabled allows the onboard SCSI device to be the first
priority boot device. The default setting is Enabled.