Filter
Top Products
22
Hot plugging and mouse restoration
It is strongly recommended that you switch off a computer before attempting
to connect it to the SmartView World. However, if this is not possible then you
need to ‘hot plug’ the computer while it is still running. There is not normally
a danger of damage to the computer, however, when mouse communications
are interrupted, often they fail to re-initialise when reconnected. The SmartView
World provides a feature to reinstate mouse communications once the necessary
connections have been made.
There are two main types of data formats used by current PC mice, these are the
older ‘PS/2’ format and the more recent ‘IntelliMouse
®
’ format introduced by
Microsoft. These use slightly different data arrangements and it is important to
know which type was being used before you hot-plugged the computer to the
SmartView World. The previous setting depends both on the type of mouse and
the type of driver, as various combinations of PS/2 and IntelliMouse are possible.
Using the incorrect restore function may produce unpredictable results and
require the computer to be re-booted.
Which restore setting do I use?
The general rule is that unless both the mouse and the driver are both
IntelliMouse compatible then you need to restore the mouse as ‘PS/2’. An
IntelliMouse can operate in either mode, whereas a PS/2 mouse cannot.
Recognising an IntelliMouse-style mouse
The IntelliMouse format was introduced to support, among other features, the
scroll wheel function. If the mouse has a scroll wheel, then it is likely to support
the IntelliMouse format. If it is a Microsoft-branded mouse, then it will usually
state that it is an IntelliMouse on its underside label.
Recognising an IntelliMouse driver
Before hot plugging to the SmartView World (or afterwards using only keyboard
control), access the Windows Control Panel of the computer and select either
the Mouse option (on Windows NT, 2000 and XP) or the System option (on
Windows 95, 98, ME). Look for the name of the driver, which will usually
include the words PS/2 or IntelliMouse.
To restore mouse operation when hot plugging:
1 Using a KVM cable set, carefully make the connections between the
keyboard, monitor and mouse sockets of the computer and the required
SmartView World port.
2 Select the port of the newly connected computer and then display the
KVM conguration menu.
3 Highlight ‘Functions’ and press .
4 As appropriate, use to highlight one of the following options:
• Restore Standard Mouse – if PS/2 mode is required, or
• Restore IntelliMouse – if IntelliMouse mode is required.
Then press .
5 Move the mouse a short distance and check for appropriate on-screen
cursor movement. If the mouse cursor darts erratically around the screen,
then cease moving the mouse. This is an indication that the chosen restore
function is incorrect. Try again using the other restore function.
Note: The restore functions predict the likely mouse resolution settings but
may not restore the exact speed or sensitivity settings that were originally
set.