Filter
Top Products
To remove and replace the optional GPIB and RS-232C cables
1 Using previous procedures, remove the following assemblies:
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive
•
Power Supply
•
Rear Panel
2 Disconnect interface cables from the main circuit board.
3 Remove the two hex standoffs connecting the GPIB cable, then slide the GPIB cable
forward and out of the rear panel.
4 Remove the two hex standoffs connecting the RS-232C cable, then slide the RS-232C
cable forward and out of the rear panel.
5 Reverse this procedure to install the GPIB and RS-232C cables.
Replacing Assemblies
To remove and replace the optional GPIB and RS-232C cables
6–13