Filter
Top Products
To apply power
CAUTION
Electrostatic discharge can damage electronic components. Use grounded wriststraps and
mats when performing any service to the logic analyzer.
1
Check that the line voltage selector, located on the rear panel, is on the correct
setting and the correct fuse is installed.
See also, "To set the line voltage" on this page.
2 Connect the power cord to the instrument and to the power source.
This instrument is equipped with a three-wire power cable. When connected to an
appropriate ac power outlet, this cable grounds the instrument cabinet. The type of power
cable plug shipped with the instrument depends on the country of destination. Refer to
chapter 7, "Replaceable Parts," for option numbers of available power cables and plug
configurations.
3
Turn on the instrument power switch located on the front panel.
To operate the user interface
To select a field on the logic analyzer screen, use the arrow keys to highlight the
field, then press the Select key. For more information about the logic analyzer
interface, refer to the Agilent Technologies 1660 Series Logic Analyzer User’s
Reference.
To set the GPIB address or to configure for RS-232C, refer to the Agilent
Technologies 1660 Series Logic Analyzer User’s Reference.
To set the line voltage
When shipped from the factory, the line voltage selector is set and an appropriate fuse is
installed for operating the instrument in the country of destination. To operate the
instrument from a power source other than the one set, perform the following steps.
Preparing for Use
To apply power
2–4