ARM R4F Computer Hardware User Manual


 
Programmer’s Model
ARM DDI 0363E Copyright © 2009 ARM Limited. All rights reserved. 2-10
ID013010 Non-Confidential, Unrestricted Access
2.7 Program status registers
The processor contains one CPSR and five SPSRs for exception handlers to use. The program
status registers:
hold information about the most recently performed ALU operation
control the enabling and disabling of interrupts
set the processor operating mode.
Figure 2-4 shows the bit arrangement in the status registers.
Figure 2-4 Program status register
The following sections explain the meanings of these bits:
The N, Z, C, and V bits
The Q bit on page 2-11
The IT bits on page 2-11
The J bit on page 2-12
The DNM bits on page 2-12
The GE bits on page 2-12
The E bit on page 2-13
The A bit on page 2-13
The I and F bits on page 2-13
The T bit on page 2-13
The M bits on page 2-14
2.7.1 The N, Z, C, and V bits
The N, Z, C, and V bits are the condition code flags. You can optionally set them with arithmetic
and logical operations, and also with
MSR
instructions and
MRC
instructions to R15. The processor
tests these flags in accordance with an instruction's condition code to determine whether to
execute that instruction.
In ARM state, most instructions can execute conditionally on the state of the N, Z, C, and V bits.
The exceptions are:
BKPT
CPS
LDC2
MCR2
MCRR2
MRC2
M[4:0]TFIAEIT[7:2]GE[3:0]NJ
Greater than
or equal to
Java state bit
Sticky overflow
Overflow
Carry/Borrow/Extend
Zero
Negative/Less than
Mode bits
Thumb state bit
FIQ disable
IRQ disable
Imprecise abort
disable bit
Data endianness bit
31 30 29 28 27 26 25 24 23 20 19 16 15 10 9 8 7 6 5 4 0
ZCVQ
IT[1:0]
DNM