Filter
Top Products
Filtering
Avaya Wireless AP-3 User’s Guide 4-63
2. Select the Filter Operation Type.
— If set to Passthru, only the enabled Ethernet Protocols listed
in the Filter Table will pass through the bridge.
— If set to Block, the bridge will block enabled Ethernet
Protocols listed in the Filter Table.
3. Configure the Ethernet Protocol Filter Table. This table is
pre-populated with existing Ethernet Protocol Filters, however, you
may enter additional filters by specifying the appropriate
parameters.
— To add an entry, click Add, and then specify the Protocol
Number and a Protocol Name.
• Protocol Number: Enter the protocol number. See
http://www.iana.org/assignments/ethernet-numbers for a
list of protocol numbers.
• Protocol Name: Enter related information, typically the
protocol name.
— To edit or delete an entry, click Edit and change the
information, or select Enable, Disable, or Delete from the
Status drop-down menu.
— An entry’s status must be enabled in order for the protocol to
be subject to the filter.