Filter
Top Products
Recovery Procedures
7-28 Avaya Wireless AP-3 User’s Guide
Follow these steps to assign the AP an IP address:
1. Open your terminal emulation program (like HyperTerminal) and
set the following connection properties:
— Com Port: <COM1, COM2, etc., depending on your computer>
— Baud rate: 9600
— Data Bits: 8
— Stop bits: 1
— Flow Control: None
— Parity: None
2. Under File -> Properties -> Settings -> ASCII Setup, enable the
Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line of
code.
3. Press the RESET button on the AP (see RELOAD and RESET
Buttons to identify the location of the RESET button).
Result: The terminal display shows Power On Self Tests (POST)
activity, and then displays a CLI prompt, similar to the example
below. This process may take up to 90 seconds.
[Device name]> Please enter password:
4. Enter the CLI password (default is public).
Result: The terminal displays a welcome message and then the
CLI Prompt:
[Device name]>