Filter
Top Products
Recovery Procedures
7-20 Avaya Wireless AP-3 User’s Guide
3. Follow one of the procedures below to load a new AP Image to the
Access Point:
— Download a New Image Using ScanTool
— Download a New Image Using the Bootloader CLI
Download a New Image Using ScanTool
To download the AP Image, you will need an Ethernet connection to the
computer on which the TFTP server resides and to a computer that is
running ScanTool (this is either two separate computers connected to the
same network or a single computer running both programs).
ScanTool detects if an Access Point does not have a valid software
image installed. In this case, the TFTP Server and Image File Name
parameters are enabled in the ScanTool’s Change screen so you can
download a new image to the unit. (These fields are grayed out if
ScanTool does not detect a software image problem.)
Preparing to Download the AP Image
Before starting, you need to know the Access Point’s IP address, subnet
mask, the TFTP Server IP Address, and the AP Image file name. Make
sure the TFTP server is running and configured to point to the folder
containing the image to be downloaded.