Filter
Top Products
Chapter 6 X330WAN CLI Commands
92 Avaya X330WAN User’s Guide
copy tftp startup-config
Use the copy tftp startup-config command to copy the device configuration
from the saved TFTP file to the NVRAM Startup Configuration NVRAM.
Note: Before downloading the Startup Configuration file to a X330W-2DS1 module,
verify that the current DS mode of the module (E1 or T1) is the same as the DS mode
in the Startup Configuration file you are about to download. If necessary, change
the X330W-2DS1’s DS mode using the ds-mode command, prior to downloading.
Syntax
copy tftp startup-config <filename> <ip>
Parameters
Example
X330WAN-2DS1-1(configure)# copy tftp startup-config
c:\p332\router1.cfg 192.168.49.10
copy tftp EW_archive
Use the copy tftp EW_archive command to download the WAN Device
Manager application into the device via TFTP. To use this command, you must have
an active TFTP server. If Avaya MultiService Network Manager is running, an
additional TFTP server is not required.
Syntax
copy tftp EW_archive <filename> <ip>
Parameters
Example
X330WAN-2DS1-1(configure)# copy tftp EW_archive c:\p330\p330web201
192.168.49.10 5
filename
The file name (full path).
ip
The IP address of the host.
filename
Embedded Web Manager image file name (full path).
ip
The IP address of the TFTP server.