Filter
Top Products
Chapter 6 X330WAN CLI Commands
122 Avaya X330WAN User’s Guide
Parameters
Example
X330W-2DS1-1(super-if:Serial2)# idle-character marks
linecode (Controller context)
Use the linecode command to select the line-code type for an E1 or T1 line. The no
form of the command restores the default line-code type of transmission.
Syntax
For T1 lines:
linecode {ami|b8zs}
For E1 lines:
linecode {ami|hdb3}
Parameters
Note: Use this command in configurations where the router or access server must
communicate with E1 or T1 fractional data lines. The T1 service provider
determines which line-code type,
ami or b8zs, is required for your T1 circuit. The E1
service provider determines which line-code type,
ami or hdb3, is required for your
E1 circuit.
Example
X330WAN-2DS1-1(config-controller:1)# no linecode
The following example specifies B8ZS as the line-code type for a T1 line:
X330WAN-2DS1-1(config-controller:1)# linecode b8zs
flags
Flags are transmitted to indicate an idle line.
marks
Marks (all ones) are transmitted to indicate an idle line. This is the default.
ami
Alternate Mark Inversion line-code type. Valid for both T1 and E1 controllers.
b8zs
B8ZS line-code type. Valid only for a T1 controller. This is the default value
for T1 lines.
hdb3
High-Density Bipolar 3 line-code type. Valid only for a E1 controller. This is
the default value for E1 lines.