Filter
Top Products
Chapter 6 X330WAN CLI Commands
210 Avaya X330WAN User’s Guide
Syntax
[no] ip access-group <policy-list-number> <direction>
Parameters
Example
X330WAN-2DS1-1(config-if:FastEthernet1)# ip access-group 110 out
ip access-list
Use the ip access-list command to create a specific Policy rule. Each rule
pertains to the source IP address, the destination IP address, the protocol, the
protocol ports (TCP/UDP, if relevant), and to the ACK bit (in TCP protocol). The
no
form of this command deletes a specific rule.
The syntax for this command is:
[no] ip access-list <policy-list-number> <access-list-index> <action>
<protocol> {<source-ip> <source-wildcard>|any|host <source-ip>}
[<operator> <port> [<port]] {<destination-ip> <destination-
wildcard>|any|host <destination-ip>}[<operator> <port>
[<port>]][established] [precedence]
Parameters
policy-list-number
An integer from 100 to 149, where 0 is the default list.
direction in|out
policy-list-number
An integer from 100 to 149.
access-list-index
An integer from 100 to 149.
action
permit|deny|deny-and-notify|fwd0-7| composite
op name
protocol
ip|tcp|udp|
integer from 1 to 255.
source-ip
IP network
source-wildcard
IP network wildcard
operator
eq|lt|gt|range
port
An integer from 1 to 65535.
destination-ip
IP network
destination-wildcard
IP network wildcard