Filter
Top Products
Chapter 6 X330WAN CLI Commands
162 Avaya X330WAN User’s Guide
Received
broadcasts
The amount of broadcasts received. This value advances only
for Ethernet interfaces.
Received giants Displays the number of packets discarded due to them
exceeding the maximum packets size.
Received
unknown
protocols
Displays the number of packets received on the interface that
were discarded due to them using an unknown or unsupported
protocol.
Input errors The total number of errors for packets received. Includes a sum
of the following errors.
CRC The Cyclic Redundancy Checksum. This usually indicates
transmission problems on the data link.
Abort An illegal sequence of 1 bit was detected on a Serial interface.
This usually indicates a clocking problem.
Packets output The total number of messages transmitted.
Bytes output The total number of bytes transmitted, including data and MAC
encapsulation packets.
Output errors The total number of errors that prevented packets from being
transmitted.
Collisions Displays the number of retransmitted messages due to an
Ethernet collision (non-Ethernet ports=0).
Interface resets The number of DTR and RTS resets (down-up fluctuation) due
to an inoperable Serial line, or when the USP interface is
administratively brought up again (USP interfaces only).
Carrier transitions The number of times the carrier detect signal state changes on a
Serial interface.
Signal status DCD, DSR, DTR, RTS, and CTS signal status (X330W-2USP
only).
ARP type The Address Resolution Protocol type used.
ARP timeout The Address Resolution Protocol timeout value.
Full/Half duplex The duplex state of the interface (for Fabric and Fast Ethernet
interfaces only).
Field Description