Filter
Top Products
Chapter 2 Installation
10 Avaya X330WAN User’s Guide
P330 Software Support for X330WAN
X330WAN enables you to connect your Avaya P330 switch to a WAN.
X330WAN can be inserted into Avaya P330 product line switches that include an
expansion slot. These include the following Avaya P330 family switches and
required software versions:
• Avaya P333T Embedded S/W Ver. 3.12 and higher
• Avaya P334T Embedded S/W Ver. 3.12 and higher
• Avaya P332MF Embedded S/W Ver. 3.12 and higher
• Avaya P333R Embedded S/W Ver. 3.12 and higher
• Avaya P333R-LB Embedded S/W Ver. 3.12 and higher
• Avaya P333T-PWR Embedded S/W Ver. 3.12 and higher
X330WAN can only be installed in the above Avaya switches using the firmware
(embedded software) version 3.12 or higher. If you need to upgrade the software,
obtain the latest version of the software from http://www.avaya.com/support
and
download it according to the instructions found in the User’s Guide that
accompanies your Avaya P330 switch.
You can view the firmware version of your Avaya switch using the
show image version command.
Installing an X330WAN Module into an Avaya P330 Switch
Note: The X330WAN modules are not hot swappable. Removing/inserting an
X330WAN with the power on resets the enclosing P330 switch.
To install an X330WAN access router module:
1 Remove the blanking plate or other expansion module from the P330 switch
designated to house the X330WAN module.
2 Insert the X330WAN module gently into the slot, ensuring that the lower
printed circuit board (PCB) is aligned with the guide rails.
The PCB, not the metal base plate, fits into the guide rail.
3 Firmly press the X330WAN module until it is completely inserted into the P330
switch. If the module is not inserted completely, the P330 switch can not
successfully reset.
4 Gently tighten the two screws on the front panel of the X330WAN module.
Note: Do not operate the Avaya P330 switch with the expansion slot open. If there is
no expansion module in the slot, cover it with the supplied blanking plate.