Filter
Top Products
Chapter 6 X330WAN CLI Commands
218 Avaya X330WAN User’s Guide
no ip composite-op
Use the no ip composite-op command to delete a composite operation from a
Policy list.
Syntax
no ip composite-op monitor <policy-list-number> <composite-operation-
index>
Parameters
Example
X330WAN-2DS1-1(configure)# no ip composite-op 101 15
set qos policy-source
Use the set qos policy-source command to set the Policy source. The default
Policy source is policy-server.
Note: Before configuring the IP access list, you must change the Policy source mode
to local.
Syntax
set qos policy-source <source>
Parameters
Example
X330WAN-2DS1-1(configure)# set qos policy-source local
show ip access-group
Use the show ip access-group command to display information about the
configured active access groups.
Syntax
show ip access-group <interface name> [<directions>]
policy-list-number
An integer from 100 to 149. 0 is the default list.
composite-operation-index
Index of operation in the table to be deleted.
Indices 0 - 12 can not be deleted.
source local | policy-server