Filter
Top Products
Chapter 3 Initial Configuration
18 Avaya X330WAN User’s Guide
—Parity - None
— Stop Bit - 1
— Flow Control - None
— Terminal Emulation - VT-100
Note: The terminal connected to the Console port must be configured with these
settings.
3 Press Enter.
4 When prompted for a Login Name, enter the default name
root.
5 When promoted for a password, enter the password
root.
Establishing a Modem Connection
A PPP connection with a modem can be established only after the X330WAN is
configured with an IP address and net-mask. Also, the parameters used in the
X330WAN must be compatible with the modem’s parameters.
All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
To configure a modem interface:
1 Connect a terminal to the console port of the X330WAN, as described in
"Establishing a Console Connection" on page 17.
2 At the prompt, type:
interface Console and press Enter.
3 Enter an IP address and subnet mask for the X330WAN to connect via its PPP
interface using the
ip address <ip address> <mask> command.
Note: The PPP interface, configured within the interface console context, must
be on a different subnet from the router interfaces.
4 Set the baud rate, PPP authentication, and PPP timeout required to match your
modem using the following commands:
speed <9600|19200|38400>
ppp authentication <chap|none|pap>
timeout absolute <time>
. The time entered is in minutes.
5Type:
async mode interactive
The CLI responds with the following:
Entering the Modem mode would occur automatically upon proprietary
modem-cable plug-in into the console port. The terminal mode would
be restored automatically upon insertion of proprietary terminal-
cable
.