Filter
Top Products
Chapter 6 X330WAN CLI Commands
142 Avaya X330WAN User’s Guide
de pre-mark (Map-class context)
Use the de pre-mark command to set the threshold, in percent of CIR, for
pre-marking of non-high priority traffic. The
no form of this command restores the
default value.
Note: This command is relevant when voice and data traffic share a single Virtual
Circuit. A higher threshold value provides more bandwidth for data traffic,
potentially reducing voice quality. Too low a value might provide more bandwidth
to voice traffic than is needed, and the data traffic is discarded. You obtain the exact
threshold value for your uses via trial and error.
Syntax
[no] de pre-mark <threshold-percent>
Parameters
Example
X330WAN-2USP-1(super-map-class)# de pre-mark 35
encapsulation frame-relay (Serial interface context)
Use the encapsulation frame-relay command to set the encapsulation of the
Serial interface to a Frame-Relay interface. The
no form of this command reverts the
encapsulation of the Serial interface to PPP.
Note: PPP is the default encapsulation.
Syntax
[no] encapsulation frame-relay [<type>]
Parameters
Example
X330W-2USP-1(super-if:Serial2)# encapsulation frame-relay ietf
threshold-percent
The threshold, in percent of CIR. The default is 100%.
type
The type of encapsulation: ietf.