Filter
Top Products
General: Device Commands
Avaya X330WAN User’s Guide 99
set logout
Use the set logout command to set the number of minutes until the system
automatically disconnects an idle session.
Syntax
set logout [timeout]
Parameters
Example
To set the number of minutes until the system disconnects an idle session
automatically:
X330WAN-2DS1-1(super)# set logout 20
Sessions will be automatically logged out after 20 minutes of idle
time.
Example
To disable the automatic disconnection of idle sessions:
X330WAN-2DS1-1(super)# set logout 0
Sessions will not be automatically logged out.
set snmp trap
Use the set snmp trap commands to add an entry to the SNMP trap receiver table
and to enable or disable the different SNMP traps for a specific receiver. First add
the rcvr_addr and then enable/disable the different traps.
Syntax
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|vlan_violation|...}
Parameters
timeout
Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).
rcvr_addr
IP address of the system to receive SNMP traps.
enable
Activate SNMP traps.
disable
Deactivate SNMP traps.
all
(Optional) Specify all trap types.