Filter
Top Products
Chapter 3 Initial Configuration
22 Avaya X330WAN User’s Guide
The primary management interface has changed.
For this change to take effect, you need to copy running-config
startup-config and then reset the device.
Enter the copy running-config startup-config and reset commands at this
stage.
Configuring E1/T1 Interfaces
All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
For a list of X330WAN default settings, see "X330WAN Default Settings" on page 28,
or use the
show controllers <port number> command to display all of the
current settings.
To configure E1 or T1 interfaces:
1Use the
show controllers <port number> command to check if your
controller’s mode is configured as E1 or T1.
Use the
ds-mode [e1|t1] command to set the controller’s mode to E1 or T1.
Changing the line type requires resetting the module.
2Use the
controller [e1|t1] <port number> command to enter the context of
the port to be configured.
The prompt changes to
X330WAN-2DS1-N(super-controller:n)#
where N is the switch number and n is the port number.
3 Use the following commands if you want to change the clock source, frame type
and linecode parameters from their default settings:
clock source [line|internal]
framing
[sf|esf] for T1 lines or framing [crc4|no-crc4|unframed] for E1
lines.
linecode [ami|b8zs] for T1 lines or linecode [ami|hdb3] for E1 lines.
cablelength [long|short] for T1 lines.
For T1 mode proceed to step 5.
4Use the
channel-group <channel-number> timeslots <timeslot-list>
command to specify the channel group and time slots to be mapped. For
example, typing
channel group 1 timeslots 1,3-5,7 configures time slots numbered 1, 3-5
and 7 to be mapped in channel-group number 1.
Proceed to step 6.
5Use the
channel-group <channel number> timeslots <timeslot list>
speed [56|64]
command to specify the channel group, time slots to be
mapped and DS0 speed in kbps. For example, typing
channel group 1 timeslots 1,3-5,7 speed 64 configures time slots
numbered 1, 3-5, and 7 to be mapped in channel-group number 1 and the DS0
speed to 64 kbps.