Filter
Top Products
3. Configuration Wizard
3.3.9.2 Start Autodetection
Start up
1. Click on to initiate the detection process.
Start address
The start address can be filled out by entering an address with the keyboard or by clicking on the ’+’ or ’-’
button.
Default = 1.
What will be executed?
All parameters of the detected devices will be downloaded locally.
Status info is given in the LogInfoViewfield during the downloading procedure.
Image 3-21
Autodetection and log info view
Wait until the status bar indicates ‘Ready’ before proceeding with further operations. Continuing with
further operations could result in the program locking d
ue to conflicts in communication sending and re-
ceiving.
Check in the ‘Log Info View’ that detection has finished successfully, if so: continue, if not : check the
system devices and the cabling connections between them. Also check if all device have been switched
on and are in full operational mode.
Repeat the procedure once again if a rectified problem prevented
successful detection originally.
R5976476 VIEWSCAPE TOOLSET 01/07/2004 25