Filter
Top Products
10. ViewScape Configuration
10.2.4.2 Test pattern set up
How to configure a test pattern
1. Click on of the 6 available patterns.
The name of the selected pattern will be displayed in the box Current pattern. (image 10-14)
Depending on the selected pattern, an extra input box appears.
Pattern Extra input box
Bytelevel
Amplitude: the amplitude (brightness) of the pattern.
Crosshatch Pixelwidth: the width of the pixels (lines). Value between 1 and 4.
HRamp no extra input box
Multiburst
Type: type of the multiburst pattern (width of the pixels). Can be a value between
0 and 7.
Blocks no extra input box
VRamp no extra input box
2. Select the color that will be used to generate the pattern.
The following options are possible:
-Red
-Green
-Blue
- Yellow(R+G)
-Cyan(G+B)
- Magenta (R + B)
- White(R+G+B)
- Loop all
Select ‘LOOP ALL’ to loop through all the available colors.
3. If the pattern has to move over the screen, check Vertical and/or horizontal and select the direction.
Note: Only available for ’Crosshatch’, ’HRamp’ and ’VRamp’ patterns.
Note: Important to avoid a burn in.
Image 10-14
Pattern choices
R5976476 VIEWSCAPE TOOLSET 01/07/2004 93