Filter
Top Products
Authorized Send Installation and Configuration Guide for imageRUNNER Machines 161
Message Cause Remedy
Application Display Name
cannot contain the
following characters: ‘x’,
‘y’, ‘z’
The [Application Display
Name (up to 20 characters)]
text box contains ‘x’, ‘y’, and
‘z’, which represent invalid
characters.
Make sure the application display
name is using valid characters.
See step 2 in
“Configuring
Optional Settings,” on p. 113.
*Warning!: Due to the size
of the Application Display
name entered, Application
Display Name may cover
the Authorized Send tab
icon.
The application display name
entered in the [Application
Display Name (up to 20
characters)] text box may be
covering up the icon on the
display tab.
If this result is not desirable,
reduce the size of the application
display name entered.
*Warning!: Due to the size
of the Application Display
name entered, Application
Display Name may be cut
off.
The application display name
entered in the [Application
Display Name (up to 20
characters)] text box may get
cut off on the display tab.
If this result is not desirable,
reduce the size of the application
display name entered.
* This denotes a warning message. A warning message will not stop the saving of the configuration
data.
6.1.11 Logs Screen Error Messages
This section explains the Logs screen error messages, along with possible causes and
remedies. For more information on the remedies, see “Configuring Log Settings,” on
p. 117.
Message Cause Remedy
Port for Syslog Server x
must be a number.
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is not a numeric value.
Enter a numeric value for the
UDP port.
Port for Syslog Server x
cannot be zero.
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is zero.
Enter a numeric value greater
than zero for the UDP port.
Port for Syslog Server x
must be a positive number.
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is a negative number.
Enter a numeric value greater
than zero for the UDP port.
Unknown host: server
An unknown host, represented
by server, is entered in the
[Syslog Server] text box.
Check the host and try again.
At least one Syslog Server
must be configured.
The [Enable Syslog] check box
is selected, but no syslog servers
are configured.
Either configure at least one
syslog server or clear the check
mark from the [Enable Syslog]
check box.