Filter
Top Products
Making Prints Using the Stack Bypass
2-17
Basic Operations
2
To print on the back side of preprinted paper, load the preprinted paper face up
into the stack bypass, as shown in the illustration below.
IMPORTANT
•
When loading paper into the stack bypass, align the paper stack neatly between
the slide guides. If the paper is not loaded correctly, a paper jam may occur.
•
If you are printing on heavyweight paper or envelopes using the stack bypass,
remove the paper or envelopes, curl their feeding edges upward approximately 1/8"
(3 mm), and then reload the paper or envelopes. Curling the feeding edges enables
the rollers to grip the paper or envelopes as they are fed into the stack bypass.
NOTE
•
If there are instructions on the paper package about which side of the paper to
load, follow those instructions.
•
When the paper is loaded into the stack bypass, the side facing down is the one
printed on.
•
If problems, such as poor print quality or paper jams occur, try turning the paper
stack over and reload it.
● If you are loading envelopes into the stack bypass:
❑
Take five envelopes, loosen them as shown, and then stack them together.
Repeat this step five times for each set of five envelopes.
Feeding
Direction
When copying on the back
side of a preprinted sheet.