Filter
Top Products
5-42
Cisco 10008 Router Hardware Installation Guide
OL-0659-13
Chapter 5 Maintaining the Cisco 10008 Router
Connecting Alarm Indicators
Figure 5-44 Closing the Ejector Levers
Step 10 Simultaneously pivot both ejector levers toward each other (until they are parallel to the faceplate) to
firmly seat the PRE in the backplane (Figure 5-44).
The PRE cycles through its power-on self-test. The Fail LED stays on briefly (about 5 to 6 seconds) and
then shuts off. If the Fail LED remains on or is flashing, go to the “Troubleshooting Installation
Problems” section on page 4-12.
PROCESSOR ONLY
32683
0
D
S0
T
3–DS0
P
OS SM–IR
E
ROUTING ENGINE
P/N
ESR-PRE3
O
UTING ENGINE
P/N
ESR-PRE3
PROCESSOR ONLY