Filter
Top Products
3-22
Cisco 10008 Router Hardware Installation Guide
OL-0659-13
Chapter 3 Installing the Cisco 10008 Router
Connecting AC Power to the Cisco 10008 Router
Figure 3-21 DC Power Cables Exiting Safety Cover
Step 11 Replace the rear safety cover, making sure that the power wires exit through the holes on the side of the
cover (Figure 3-21).
Step 12 Go to the “Connecting a Video Terminal to the PRE Console Port” section on page 3-30 to continue the
installation.
Connecting AC Power to the Cisco 10008 Router
The Cisco 10008 router can be powered directly from the facility VAC input through the AC PEM
(100-240VAC). The AC PEM is provided with an IEC 320 250V, 20A power cord with a male type
connector (16A rating for Europe) for the attachment of power cords used throughout the world.
Caution The 20A connector on the AC PEM is incompatible with the 15A power strips that are used in most
equipment racks. Wiring codes prevent the AC-input power cable from being used with the power strips
in equipment racks.
Note The AC power cord that connects to the PEM power cord and then to the building VAC is not shipped
with the Cisco 10008 router. You must order this power cord separately.
30025