CHAPTER
4-1
Cisco 10008 Router Hardware Installation Guide
OL-0659-13
4
Starting and Configuring the Router
This chapter provides information on powering on the system, basic file system information, and
installation troubleshooting procedures.
• Powering On the System, page 4-1
• Configuring the Cisco 10008 Router at Startup, page 4-2
• Formatting Flash Memory Cards and Disks, page 4-6
• Managing the File Systems, page 4-7
• Managing System Boot Parameters, page 4-9
• Predeployment Testing, page 4-11
• Troubleshooting Installation Problems, page 4-12
Powering On the System
When all of the interfaces are connected, perform a visual check of all connections and then check that:
• The ejector levers on each line card are in the locked position.
• All top and bottom line card retaining screws are tight.
• All network interface cables are connected to the line cards.
• The console terminal is turned on.
• A PCMCIA flash memory card installed in the PRE.
You are now ready to power on the system for the first time using the following procedure: