Filter
Top Products
3-31
Cisco 10008 Router Hardware Installation Guide
OL-0659-13
Chapter 3 Installing the Cisco 10008 Router
Connecting a Video Terminal to the PRE Console Port
Figure 3-31 Console Port Connection on the PRE Module
Step 1 Connect one end of the RJ-45 crossover cable to the serial RJ-45 port (CON) on the PRE module
(Figure 3-31).
Step 2 Run the cable up and through the cable management bracket and connect the other end of the RJ-45
crossover cable to the RJ-45 adapter (Figure 3-32). If your terminal is equipped with a:
• DB-25 serial connector, use the RJ-45-to-DB-25 adapter.
• DB-9 serial connector, use the RJ-45-to-DB-9 adapter.
Figure 3-32 Connecting an RJ-45-to-DB-9 Console Cable Adapter
Step 3
Connect the adapter to your video terminal to complete the cable connection.
Step 4 Power on your video terminal.
Step 5 Configure your video terminal to match the following default console port settings:
• 9600 baud
• 8 data bits
• No parity generation or checking
• 1 stop bit
• No flow control
30027
CONSOLE
ETHERNET
LINK
AUX
S
LO
T
0
S
L
O
T
1
CISCO
10000
LINK
30028