Filter
Top Products
Chapter 6 Performing Administrative Tasks
Using Discovery and Managing Devices
6-12
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Related Topic
Importing Devices, page 6-28
Managing Devices, page 6-2
Set Up Devices
You must set up devices so the WLSE can discover and manage them. This section
describes both required and optional setup tasks for:
• Set Up Access Points and Bridges, page 6-12
• Set Up Routers and Switches, page 6-15
• Set Up AAA Servers, page 6-16
Set Up Access Points and Bridges
You can set up access points and bridges in two ways:
• By using the WLSE’s automatic configuration option for first-time device
configuration (select Configuration > Auto Update). For more information,
see Automating Configurations, page 3-151.
• By opening a web browser session on each device and perform the tasks in
the following table. To use this method, you must first configure each access
point or bridge for web browsing.
Table 6-4 Set Up Procedures for Access Points and Bridges
Tasks Procedure Notes
1. Enable Cisco
Discovery Protocol
(CDP).
1. In the Summary Status page, click
Setup. The Cisco Services Setup
page appears.
2. Under Services: Cisco Services, click
Cisco Discovery Protocol. The CDP
Setup page appears.
3. Select Enabled. Click Apply or OK.
CDP is required for the WLSE to
discover devices on the network.