2-15
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Chapter 2 Fault Monitoring
Managing Profiles
Specifying Fault Thresholds
This option allows you to set polling and exception threshold values collected
from the devices you are monitoring.
The threshold values you set in this window will determine how the faults are
displayed in the Faults > Display Faults subtab.
Note Your login determines whether you can use this option.
Threshold choices include the following options:
• Access Point—See Setting Access Point Fault Thresholds, page 2-15.
• Switch—See Setting Switch Fault Thresholds, page 2-17.
• Router—See Setting Router Fault Thresholds, page 2-19.
• LEAP—See Setting Server Response Time, page 2-19.
• Radius—See Setting Server Response Time, page 2-19.
• EAP-MD5—See Setting Server Response Time, page 2-19
Setting Access Point Fault Thresholds
Using this option, you can set up thresholds for access point faults. When the
thresholds are exceeded, faults are generated and can be viewed under Faults >
Display Faults.
Procedure
Step 1 Select any of the following to set values for:
• SNMP Reachable—Go to Step 2.
• RF Port Status—Go to Step 2.
• RF Port Utilization—Go to Step 4.
• RF Port Packet Errors—Go to Step 4.
• RF Port WEP Errors—Go to Step 4.
• RF Port FCS Errors—Go to Step 4.
• Ethernet Port Status—Go to Step 2.