Chapter 3 Configuring Devices
Using the Templates
3-32
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
78-14947-01
Step 3 Enter the following information:
Step 4 Using this option you can:
• Add a new VLAN—See Adding a New VLAN, page 3-33.
• Delete an exiting VLAN from a Device—See Deleting an Existing VLAN,
page 3-36.
Field Description
VLAN (802.1Q)
Tagging
From the list, select one of the following:
• Enabled—Use this setting to allow IEEE 802.1Q
protocol tagging on VLAN packets.
The IEEE 802.1Q protocol is used to interconnect
multiple switches and routers, and for defining
VLAN topologies.
• Disabled—Use this setting to not allow tagging.
Native VLAN ID Enter identification number of the access point’s native
VLAN.
Note This setting must agree with the native VLAN ID
setting on the switch.
Single VLAN ID
which allows
unencrypted
packets
Enter an identification number to allow unencrypted
packets. An entry with a value of 0 (zero) requires the use
of encryption.
Optionally allow
Point-to-point
Packet Encryption
From the list, select one of the following:
• Yes—Use this setting to allow point-to-point
encryption.
• No—Use this setting to not allow point-to-point
encryption.