Filter
Top Products
Receiving Documents ManuallyManual Mode
You will want to set your MultiPASS C3000 to receive documents
manually when you want to personally check each incoming call to see if
it is from a fax or from a person. You must have a telephone attached to
the MultiPASS C3000.
When the MultiPASS C3000 rings, pick up the telephone.
❍ If you hear a persons voice, start your conversation. If the caller
wants to send a document after talking to you, wait on the line until
you hear a slow beep or silence (depending on the sending fax unit),
then press START/COPY to receive the document.
❍ If you hear a slow beep or silence, another fax is trying to send you a
document. Press START/COPY.
Your MultiPASS C3000 begins receiving the
document.
❍ Hang up the telephone after the MultiPASS C3000 displays RECEIVE.
If you dont hang up, the MultiPASS C3000 beeps intermittently for
a few seconds after you receive the document. To disable the beeping,
turn off the Off Hook Alarm option in the Advanced: Send Fax
dialog box. (See page 8-5 for details.)
Using the Telephone to Receive a Fax
If you have a telephone connected to the MultiPASS C3000, you can
start receiving a document manually by entering a two-digit ID code
from the phone. This is particularly convenient if you are using a
cordless phone and you answer the phone away from the MultiPASS
C3000.
To use this feature, the telephone must be plugged into the telephone
jack of the MultiPASS C3000 (see your Setup Guide for details). The
Remote Receive option must be enabled in the Advanced: Receive Fax
dialog box. (The default is enabled.) For details, see page 8-8.
START/COPY
MPC-3000—USERS MANUAL/V000/07-97
Receiving Faxes
Chapter 5 Receiving Faxes 5-3