Filter
Top Products
Section 7 COPIER MANAGEMENT
7-42
The state that the copier enters at the end of warm-up or when the [Reset] key is pressed is called the “initial mode”. The modes, functions and
other settings that are automatically pre-set for the initial mode are called “default settings”. These default settings are separated into two
categories: “Copy defaults” and “Machine defaults” and can be changed as desired to suit your copying needs.
Machine default settings
The following table indicates the machine default settings available in this copier. Change any or all of the settings as desired in order to make
the most effective use of your copier.
Default settings
Default setting Description
Available
settings
Factory
setting
Reference
page
Auto
drawer[cassette]
switching ON/OFF
If the paper in one drawer[cassette] runs out during copying,
the automatic drawer[cassette] switching function will
switch paper feed from the empty drawer[cassette] to
another drawer[cassette] that contains the same size of
paper in the same orientation for uninterrupted copying. To
enable this function, it is necessary to turn the related
setting “On”.
On / Off On 7-46
In order to prevent a drawer[cassette] that holds a different
type of paper from being switched to when the automatic
drawer[cassette] switching function is turned ON, it is
necessary to select “Feed same paper type” as well.
All types of paper /
Feed same paper
type
All types of paper
Paper size
(drawer[cassette]
No.1 - No.4)
Sets the size of paper that is loaded in drawers[cassettes]
No.1 through No.4.
If you want the size to be detected automatically, select
“Auto Detection” (Automatic size detection). If you want to
manually set the size of paper, select “Standard sizes”.
* The setting for drawer [cassette] No.1 is not available on
duplex copiers because the Duplex Unit is installed in its
place.
* This setting is only available when the optional Paper
Feeder is installed on your copier.
Auto Detection /
Standard sizes
Auto Detection 7-47
When “Auto” is selected
Select “Centimeter” or “Inch”.
Centimeter
Inch
Centimeter
<If you select “Standard sizes”>
You can then select the paper size.
A3
A4
A4R
A5R
B4
B5
B5R
Folio
11" × 17"
8
1/2" × 14"
11" × 8
1/2"
8
1/2" × 11"
5
1/2" × 8 1/2"
8
1/2" × 13"
– – –
Paper type
(drawer[cassette]
No.1 - No.4)
Sets the paper type for drawers [cassettes] No. 1 through No.
4.
* The setting for drawer[cassette] No.1 will not be available
on duplex copiers because the Duplex Unit is installed in
its place.
* The setting for drawer[cassette] No.2 through No.4 will
only be available when the optional Paper Feeder is
installed on your copier.
* When an optional Document Finisher is installed, be sure
to configure this setting to match the paper weight. An
incorrect setting can cause paper jams.
Plain
Preprinted
Recycled
Letterhead
Color [Colour]
Prepunched
Bond
High quality
Rough
Custom 1 – Custom 8
Plain 7-48