Filter
Top Products
Control panel message types
Control panel messages are divided into three types, depending on their severity.
● Status messages
● Warning messages
● Error messages
Within the error message category, some messages are ranked as Critical error messages.
This section explains the differences between the control panel message types.
Status messages
Status messages reflect the current state of the printer. They inform you of normal printer
operation and require no interaction to clear them. They change as the state of the printer
changes. Whenever the printer is ready, not busy, and has no pending warning messages,
the status message Ready is displayed if the printer is online.
Warning messages
Warning messages inform you of data and print errors. These messages typically alternate
with the Ready or Status messages and remain displayed until the
button is pressed. If
CLEARABLE WARNINGS is set to JOB in the printer’s configuration menu, these
messages are cleared by the next print job.
Error messages
Error messages communicate that some action must be performed, such as adding paper or
clearing a paper jam.
Some error messages are auto-continuable; if AUTO CONTINUE=ON the printer will
continue normal operation after displaying an auto-continuable error message for 10 seconds.
NOTE
Any button pressed during the 10-second display of an auto-continuable error message will
override the auto-continue feature and the function of the button pressed will take
precedence. For example, pressing the M
ENU
button will display the main menu.
Critical error messages
Critical error messages inform you of a device failure. Some of these messages can be
cleared by turning the printer off and then on. These messages are not affected by the
AUTO CONTINUE setting. If a critical error persists, service is required.
The following table lists and describes control panel messages, in alphabetical order.
ENWW Control panel message types 129