Filter
Top Products
4. Push down the media lift plate until it locks.
5. Load media face-up, making sure that the corners of the media fit under the front tabs.
NOTE
For best performance, load the tray completely full without splitting the ream of paper.
Splitting the ream might cause a multi-feed problem, which could result in a paper jam. The
capacity of the paper tray can vary. For example, if you are using 75 g/m
2
(20 lb) paper, the
tray holds a full ream of 500 sheets. If the media is heavier than 75 g/m
2
(20 lb), the tray will
not hold a full ream, and you must reduce the number of sheets accordingly. Do not overfill
the tray because the printer might not pick up the paper.
6. Slide the media width guides in making sure that they gently touch the paper. Insert the
tray into the printer.
7. Insert the tray into the printer. The printer will display the tray’s type and size
configuration. To specify specific custom dimensions, or if the type is not correct, press
the
key when the printer prompts To change size or type press . To enter specific
dimensions or change the size selection from ANY CUSTOM to custom, see
To
configure a tray to match print job settings.
8. If the configuration is correct, press
to clear the message.
84 Chapter 4 Printing tasks ENWW