Filter
Top Products
To set manually feed prompt
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight TRAY BEHAVIOR.
7. Press
to select TRAY BEHAVIOR.
8. Press
to highlight MANUALLY FEED PROMPT.
9. Press
to select MANUALLY FEED PROMPT.
10. Press
or to select ALWAYS or UNLESS LOADED.
11. Press
to set the behavior.
12. Press M
ENU
.
To set the printer default for PS Defer Media
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight TRAY BEHAVIOR.
7. Press
to select TRAY BEHAVIOR.
8. Press
to select PS DEFER MEDIA.
9. Press or select ENABLED or Disabled.
10. Press
to set the behavior.
11. Press M
ENU
.
PowerSave Time
The adjustable PowerSave Time feature reduces power consumption when the printer has
been inactive for an extended period. You can set the length of time before the printer goes
into PowerSave mode to 1 MINUTE, 15 MINUTES, 30 MINUTES, 60 MINUTES, 90
MINUTES, 2 HOURS, or to 4 HOURS. The default setting is 30 MINUTES.
NOTE
The printer display dims when the printer is in PowerSave mode. PowerSave mode does not
affect printer warm-up time.
52 Chapter 2 Control panel ENWW