Filter
Top Products
Control panel message Description Recommended action
REPLACE FUSER KIT
For help press
alternates with
REPLACE FUSER KIT
To continue press
The fuser is nearing the end of its useful
life and the SUPPLIES LOW setting in
SYSTEM SETUP is set to STOP.
1. Order the fuser kit.
2. To continue printing, press
.
3. To replace the fuser kit, perform the
following steps:
● Open the top cover.
● Loosen the blue thumb screws.
● Remove the old fuser unit.
● Install a new fuser unit and
secure with thumb screws.
● Close the top cover.
NOTE
If you want to continue printing past the
end-of-life message, the fuser kit count
must be reset using the printer control
panel. Please note that the end-of-life
message is provided as a customer
service, and printing past it is likely to
result in print quality degradation in the
near future. Once the fuser kit count has
been reset after an end-of-life message,
feedback on the kit's remaining life will
be incorrect until the kit is replaced and
the count is reset again.
To reset the fuser count
1. Press M
ENU
to enter the MENUS.
2. Press
and to highlight
CONFIGURE DEVICE.
3. Press
to select CONFIGURE
DEVICE.
4. Press
and to highlight RESETS.
5. Press
to select RESETS.
6. Press
and to highlight RESET
SUPPLIES.
7. Press
to select RESET SUPPLIES.
8. Press
and to highlight NEW
FUSER KIT.
9. Press
to select NEW FUSER KIT.
10. Press
and to highlight YES.
11. Press
to select YES.
The fuser count is reset and the printer
is ready to use.
Control panel messages (continued)
150 Chapter 8 Problem solving ENWW