Filter
Top Products
Control panel message Description Recommended action
SIZE MISMATCH
TRAY XX=[SIZE]
For help press
alternates with
Ready
The tray is loaded with media longer or
shorter in the feed direction than the size
configured for the tray.
1. Adjust the side and rear media
guides against the paper.
2. If the media used is letter, A4,
executive, JIS B5, A5, or legal, the
tray switch should be set to
STANDARD. Set the tray switch to
CUSTOM for all other media sizes.
The tray switch must be set before
the size can be selected from the
control panel.
3. If necessary, press
after the tray
is closed to reset the paper size or
type.
Tray X
[TYPE] [SIZE]
Size detected by tray
alternates with
Tray X
[TYPE] [SIZE]
To change size or type
press
The printer is reporting the current
configuration of tray X. The tray switch is
in the STANDARD position.
1. If the configuration of the size and
type is correct, press
to clear the
message.
2. To change media size or type, press
.
Use
and to highlight the size or
type, and then press
to select.
3. If action is required to change the
size, a message with instructions
will appear after the selection is
attempted.
Tray X
[TYPE] [SIZE]
Size specified by user
alternates with
TRAY XX [TYPE] [SIZE]
To change size or type
press
The printer is reporting the current
configuration of tray X. The tray switch is
in the CUSTOM position.
1. If the configuration of the size and
type is correct, press
to clear the
message.
2. To change media size or type, press
.
Use
and to highlight the size or
type, and then press
to select.
3. If action is required to change the
size, a message with instructions
will appear after the selection is
attempted.
4. See
Configuring input trays for more
details.
TRAY X EMPTY
[TYPE] [SIZE]
alternates with
Ready
The specified tray is empty and the
current job does not currently need this
tray to print.
Refill the tray at a convenient time.
TRAY X OPEN
For help press
alternates with
Ready
The specified tray is open or not closed
completely.
Close the tray.
Control panel messages (continued)
ENWW Control panel messages 155