Filter
Top Products
Control panel message Description Recommended action
REPLACE TRANSFER KIT
For help press
alternates with
REPLACE TRANSFER KIT
To continue press
The transfer unit is nearing the end of its
useful life and the SUPPLIES LOW
setting in SYSTEM SETUP is set to STOP.
Continued
To reset the transfer unit count
1. Press M
ENU
to enter the MENUS.
2. Press
and to highlight
CONFIGURE DEVICE.
3. Press
to select CONFIGURE
DEVICE.
4. Press
and to highlight RESETS.
5. Press
to select RESETS.
6. Press
and to highlight RESET
SUPPLIES.
7. Press
to select RESET SUPPLIES.
8. Press
and to highlight NEW
TRANSFER KIT.
9. Press
to select NEW TRANSFER
KIT.
10. Press
and to highlight YES.
11. Press
to select YES.
The transfer unit count is reset and the
printer is ready to use.
Request accepted
please wait
The printer has accepted a request to
print an internal page, but the current job
must finish printing before the internal
page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not
completed successfully.
Attempt upgrade again.
Resetting Kit Count YES is selected in the Reset Supplies
menu, to reset the counts for any of the
supplies that cannot be detected as new.
No action necessary.
Restoring... The printer is restoring settings. No action necessary.
Restoring...
factory settings
The printer is restoring factory settings. No action necessary.
Rotating <COLOR>
motor
To exit press
S
TOP
key
A component test is in progress; the
component selected is the <color>
Cartridge motor.
Press S
TOP
when ready to stop this test.
Rotating motor
To exit press
S
TOP
key
The printer is executing a Component
Test and the component selected is a
motor.
Press S
TOP
when ready to stop this test.
Setting saved A menu selection has been saved. No action necessary.
Control panel messages (continued)
154 Chapter 8 Problem solving ENWW