Filter
Top Products
Clearing jams
Each section below corresponds with a jam message that might appear on the control panel.
Use these procedures to clear the jam.
Jam in Tray 1
1. Open Tray 1.
2. Remove any jammed paper from Tray 1.
3. Reload paper in Tray 1 and check to make sure the media is located correctly.
NOTE
Do not load media above the fill tabs.
4. Confirm that the guides are in the correct position.
5. Close Tray 1.
6.
To continue printing, press
, and then press .
162 Chapter 8 Problem solving ENWW