Filter
Top Products
4. Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and
set them aside.
5. Slide out the formatter board and set it on a clean, flat, grounded surface.
6. To replace a DDR DIMM that is currently installed, spread the latches apart on each side
of the DIMM slot, lift the DDR DIMM up at an angle, and pull it out.
*2P128SE0376*
*2P128SE0376*
*
2
P
1
2
8
S
E
0
3
7
6
*
*
2
P
1
2
8
S
E
0
3
7
6
*
7. Remove the new DIMM from the antistatic package. Locate the alignment notch on the
bottom edge of the DIMM.
ENWW Installing memory 195