Filter
Top Products
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
NGA 2000
6 - 9
Main Menu — Technical level configuration
↓↓
System set up
↓↓
Front panel control
↓↓
In the menu "Front Panel Control" you can set up several display parameters. You can set
up the same parameters in the menu "Front Panel Control" of the "Expert controls and set
up" menus (see 5.4.1 p. 5-48).
Set up parameters:
♦ Select any line of variables with the ↓↓ -key or the ↑↑ -key.
♦ Select the variable with the ENTER key or the →→ -key.
♦ Select any digit with the ←← -key or the →→ -key and adjust a new value with
the ↑↑ -key or the ↓↓ -key
resp. select the whole parameter with the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new value with the ENTER key or cancel and go back to the last value with
the F2 key.
Lines of variables "LCD brightness" and "LCD contrast":
In these two lines you can determine the quality of the LCD reproduction. The best values
depend on your position to the screen and on the light of the environment.
♦ Options: 20 to 100% for LCD brightness and 10 to 80% for LCD contrast.
♦ Usually: 70 to 90% (brightness) and 20 to 30% (angle).
♦ Caution: Be careful with the changing of these values! Perhaps you can not read the
display any longer if you use very extreme values! It is not possible to load standard
values via keyboard!
HOME ESCAPE INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Front Panel Control
LCD brightness: 70 %
Reading refresh rate: 1 s
Drop out of menus after: 10 min
LCD contrast: 25 %
6.1.2 System set up
Front Panel Control