Filter
Top Products
2 Structure of Menus
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
NGA 2000
2 - 1
Notes:
*
In the menu structure shown above, you will find the most important ramifications of the MLT software 3.1.X for the
MLT platform and analyzer versions. The menu points related to the CLD analyzer module are marked with
"AM".
They belong to the CLD software revision number 2.3.
*
At each menu point of the "Expert controls" and "Technical level" you can find which functionality will be set up:
AM (Analyzer M
odule), CM (
Control M
odule), I/O (
Input-/O
utput Module).
*
Menu lines ending with three points (...) are followed by submenus with further functions and set-ups.
-
Range set-up
-
Range and
functional control
-
Ozonator power
enable/disable
-
Measurement mode
selection: NO/NOx
-
Zeroing...
-
Spanning...
- Expert analyzer
controls...
(AM)
- Auxiliary module
controls...
(I/O's: SIO, DIO)
- System set up...
(CM)
- Analyzer module set up...
(AM)
- Auxiliary module set up...
(Other I/O's)
- System calibration...
(CM)
- System set up...
(CM)
- Service menus...
(AM, CM, I/O's:
SIO, DIO and other I/O's)
- Diagnostic menus...
(AM, CM, I/O's:
SIO, DIO and other I/O's)
- Other module
diagnostic menus...
(Other I/O's)
- Listing of all modules...
(AM, CM, I/O's:
SIO, DIO and other I/O's)
Main Menu
Basic controls... (AM)
Expert controls
and set up...
Technical level
configuration...