Filter
Top Products
System Calibration
Supplement - 14 NGA 2000 90003749(1) [NGA-e (CLD-Software 2.3/MLT-Software 3.1.X)] 04/98
3.4.1 Control via menu system
The possibility to control via menu is located in the menu page „Calibration/Test
procedures“. There can be started and stopped any kind of system calibration respectively
test procedure.
SCTESTMOD
SCCALTYPE2
SCPROGSTEP
SCCALTIME1
SCCALTIME2
During a running SYSCAL there can be watched current information:
• running calibration type
• running program step of user defined program (other modes than user program show a
„0“!)
• consumed calibration time
• calibration time of last valid SYSCAL
Expert controls and set up...
↓
System Calibration...
↓
Calibration/Test procedures...
↓
Calibration/Test Procedures
Start Zeroing all ranges !
Start Zeroing and Spanning all ranges !
Start calibration program !
Cancel calibration !
Calibration Procedures in Test-Mode: No
Test Procedures...
Calibration type: Zero-Cal
Program step: 1
Calibration time: 16 s
Previous calibration time: 57 s
RESULTS